Dental E Generator 5 Water Spray Shadowless Handpiece

Dental E Generator 5 Water Spray Shadowless Handpiece

Product parameter:

5water spray LED handpiece

Features:

E Generator handpiece

1. Principles of cleaning and caring for dental palms

(1) Appropriate cleaning and maintenance methods should be selected according to the internal structure and function of the tooth handle.

(2) Special dental hand instruments must be cleaned and maintained in accordance with the manufacturer's or supplier's instructions.

2. How to clean the teeth

(1) Manual cleaning method

① After using the dental handpiece, use the water and air system of the complete dental treatment table to flush the internal water and air channels 

of the dental handpiece for 30 seconds with the needle attached.

②Remove the tooth hand piece from the interface or connection line quickly, remove the yellow and remove the surface contamination. Using a dental hand with an optical fiber, the particles and dust on the surface of the optical fiber can be blown with an air gun, and the stains on the surface of the optical fiber can be wiped; The surface of the dental floss can be cleaned with a soft brush under running water.

③ To clean the air flow channel of the toothpick, use pressure canned cleaning oil, or use a pressure water gun to wash the inner channel of the air intake hole, and then use a pressure air gun to dry it. Mobile phones with removable parts must be disassembled and cleaned; non-removable dental implants can be cleaned with a pressurized water gun; After cleaning the gear arm with a pressurized water gun, dry the internal air circuit as quickly as possible with a pressurized air gun to avoid damage to the bearing; the pressure of pressurized water gun and pressurized air gun should be between 200kPa and 250kPa and should not exceed the pressure specified in the dentist's instruction manual; Do not soak the hands in liquid cleaning solutions.

3. Maintenance of dental instruments

(1) Use pressure-canned lubricating oil to connect the appropriate lubricating adapter or coupling to introduce the lubricating oil into the gear arm.

(2) The part that holds the toothpick tool (chicken or three-valve spring) should be lubricated daily.

(3) Internal oil chain type gear arm must use steel or three-lobe spring and grease pen to lubricate the bearings.

(4) For lubrication of low-speed tooth bending machines and tooth straightening machines, refer to the lubrication methods above (if applicable) and refer to the manufacturer's or supplier's instructions for specific lubrication methods.